NewFEIMAS
Refer to Revision Record on page 2.
T.Anzai
Nov. 20, 2008
K.Okada
Rev
04
03
PAGE
93
/
138
PFU LIMITED
P1PA03334-B30X/6
Refer to Revision Record on page 2.
T.Anzai
July 7, 2008
K.Okada
Refer to Revision Record on page 2.
K.Okada
K.Okada
DESCRIPTION
CHECK
DATE
T.Anzai
APPR.
K.Okada
K.Okada
Aug.19, 2005
DESIG
N
DESIG
.
CUST.
I.Fujioka
I.Fujioka
T.Anzai
CHECK
fi-5530C/fi-5530C2
IMAGE SCANNER
MAINTENANCE MANUAL
APPR.
TITLE
DRAW.
No.
Feb.23, 2007
05
Section 5-1-1
Chapter 5 Adjustment/Settings
5-1 Maintenance mode
The scanner supports built-in Maintenance mode that allows users to check scanner’s performance and settings. This section
gives the description of Maintenance mode.
5-1-1 Activating the Maintenance mode
(1) How to activate the Maintenance mode
Open the ADF. Press the power button once while pressing down Scan button. Keep pressing Scan button until Screen T02
is displayed. This will put the scanner into Maintenance mode. While in Maintenance mode, the scanner interface is
off-line.
The following display appears during power up processing in Maintenance mode.
Screen T01
Function
No. Display
Power LED
Scanner status
ON
Initial processing in Maintenance mode
When Maintenance mode is activated normally after the initial processing, the following display appears.
Screen T02
Function
No. Display
Power LED
Scanner status
ON
Maintenance
mode
#1
selected
(2) Test/adjustment items of the Maintenance mode
The following lists test/adjustment items #1 ~ #7 that are supported by the scanner.
Mode #1: Paper transportation test and Sensor test
Mode #2: Main scanning/Sub-scanning magnification adjustment
Mode #3: Offset adjustment
Mode #4: White level adjustment
Mode #5: Consumables counter display and reset
Mode #6: Miscellaneous information display
Mode #7: EEPROM data restore
