NewFEIMAS
Refer to Revision Record on page 2.
T.Anzai
Nov. 20, 2008
K.Okada
Rev
04
03
PAGE
23
/
138
PFU LIMITED
P1PA03334-B30X/6
Refer to Revision Record on page 2.
T.Anzai
July 7, 2008
K.Okada
Refer to Revision Record on page 2.
K.Okada
K.Okada
DESCRIPTION
CHECK
DATE
T.Anzai
APPR.
K.Okada
K.Okada
Aug.19, 2005
DESIG
N
DESIG
.
CUST.
I.Fujioka
I.Fujioka
T.Anzai
CHECK
fi-5530C/fi-5530C2
IMAGE SCANNER
MAINTENANCE MANUAL
APPR.
TITLE
DRAW.
No.
Feb.23, 2007
05
Section 1-6-2
1-6-2 Loading Documents for Scanning
1. Align the edge of the documents.
1) Confirm that all the documents have the same width.
2) Check the number of the sheets in the document stack.
The standard number of sheets that can be loaded on the scanner is as follows:
- A4-size paper or smaller that makes a document stack of 10mm or less (100 sheets at 80g/m
2
or at 20 lb)
- Over A4-size paper that makes a document stack of 5mm or less (50 sheets at 80g/m
2
or at 20 lb)
2. Fan the document as follows:
1) Lightly grip both ends of the documents with both hands, and bend the
documents as shown on the right.
2) Hold the documents firmly with both hands and bend them back as
shown on the right so that the bent section rises up in the middle of the
stack.
3) Repeat steps 1) to 2) a couple of times.
4) Rotate documents 90 degrees, and fan again.
3. Align the top of the documents.
4. Load the documents on the ADF paper chute (Chute unit).
Set the documents face-down in the ADF paper chute (Chute unit) so that the side to be scanned faces towards the
ADF paper chute (Chute unit).
Note: Set the documents so that the stack will not surpass the line
mark located at the side guide.
For A4-size paper or smaller, set the documents so that the
stack will not surpass the “Letter/A4/Smaller” line mark.
For paper over the A4-size, set the documents so that the
stack will not surpass the “Over Letter/A4 Size” line mark.
