NewFEIMAS
Refer to Revision Record on page 2.
T.Anzai
Nov. 20, 2008
K.Okada
Rev
04
03
PAGE
65
/
138
PFU LIMITED
P1PA03334-B30X/6
Refer to Revision Record on page 2.
T.Anzai
July 7, 2008
K.Okada
Refer to Revision Record on page 2.
K.Okada
K.Okada
DESCRIPTION
CHECK
DATE
T.Anzai
APPR.
K.Okada
K.Okada
Aug.19, 2005
DESIG
N
DESIG
.
CUST.
I.Fujioka
I.Fujioka
T.Anzai
CHECK
fi-5530C/fi-5530C2
IMAGE SCANNER
MAINTENANCE MANUAL
APPR.
TITLE
DRAW.
No.
Feb.23, 2007
05
Section 4-7-1
4-7. Removing / Mounting Chute Unit, Stacker Unit, PCB Unit and Covers
4-7-1. Removing/Mounting the Chute unit (ADF paper chute)
Refer to
Section 6-25
for the part number of the replacement part.
<Removing>
Turn the Chute unit (ADF paper chute) upward,
and Pull it out from the scanner. There is the
craw on top of tabs to hook the Chute unit
(ADF paper chute).
<Mounting>
Hold the Chute unit (ADF paper chute) and insert its tabs into
the holes on the rear side of the scanner as shown in the figure
on the right so that the side guides face up.
4-7-2. Removing/Mounting the Stacker Unit
Refer to
Section 6-24
for the part number of the replacement part.
<Removing>
(1) Slide the Stacker unit to right until it
touches the side face of cover. Turn the
Stacker unit up about 45 degrees. Then
pull and detach a fulcrum part, which
touches the side face of cover.
(2) Slide the Stacker to left until tit touches
another end. Pull and detach another
fulcrum part.
<Mounting>
Follow the above procedure in reverse.
About 45 degree
Claw
Stacker unit
Scanner
Fulcrum
Scanner
Chute unit
（
ADF paper chute
）
Tab
Chute unit
(ADF paper chute)
