NewFEIMAS
Refer to Revision Record on page 2.
T.Anzai
Nov. 20, 2008
K.Okada
Rev
04
03
PAGE
136
/
138
PFU LIMITED
P1PA03334-B30X/6
Refer to Revision Record on page 2.
T.Anzai
July 7, 2008
K.Okada
Refer to Revision Record on page 2.
K.Okada
K.Okada
DESCRIPTION
CHECK
DATE
T.Anzai
APPR.
K.Okada
K.Okada
Aug.19, 2005
DESIG
N
DESIG
.
CUST.
I.Fujioka
I.Fujioka
T.Anzai
CHECK
fi-5530C/fi-5530C2
IMAGE SCANNER
MAINTENANCE MANUAL
APPR.
TITLE
DRAW.
No.
Feb.23, 2007
05
Section A.6
When using a scanner, the following message may be displayed.
If this message appears, replace consumables following the instructions below.
< If replacing consumables immediately >
1. Check [This message not display again].
2.
In cases where consumables are replaced after completing all documents being scanned, click [Ignore].
In cases where scanning is stopped for an immediate replacement, click [Cancel].
3.
Following
Section 1-8
, replace the consumables.
4.
Select [Page counter] from [Device setup], click [Clear] button to reset the consumables counter.
Note: When [This message not display again.] is marked, the message will not appear until the consumable
counter is reset and it reaches the specified value (Pad: 90,000 sheets, Pick roller: 190,000sheets).
< If replacing later (immediate replacement is impossible) >
1.
If it is not necessary to display this message again, check [This message not display again]*. If it is
necessary to display this message again after scanning xxx pages, check [Warns again after scanning
xxx pages].
2.
If the scanning is continued, click [Ignore] and close the message. If the scanning is stopped, click
[Cancel] and close the message.
3.
Replace consumables as soon as possible or when this message appears next time.
4.
After the replacement, click [Clear] of [Device Setup] under [Page Counter] to reset the consumables
counter.
(* If [This message not display again] is checked, this message will not appear before the consumables
counter is reset.)
♦
Power saving:
Specify when the lamp turns off. This is the elapsed time after a scan is complete.
