NewFEIMAS
Refer to Revision Record on page 2.
T.Anzai
Nov. 20, 2008
K.Okada
Rev
04
03
PAGE
88
/
138
PFU LIMITED
P1PA03334-B30X/6
Refer to Revision Record on page 2.
T.Anzai
July 7, 2008
K.Okada
Refer to Revision Record on page 2.
K.Okada
K.Okada
DESCRIPTION
CHECK
DATE
T.Anzai
APPR.
K.Okada
K.Okada
Aug.19, 2005
DESIG
N
DESIG
.
CUST.
I.Fujioka
I.Fujioka
T.Anzai
CHECK
fi-5530C/fi-5530C2
IMAGE SCANNER
MAINTENANCE MANUAL
APPR.
TITLE
DRAW.
No.
Feb.23, 2007
05
Section 4-10-5
4-10-5. Replacing the Lamp SR (for ADF front)
As the dust-proof area in the scanner is opened by the following procedure, do not replace the following parts in a dusty
room.
Refer to
Section 6-5
for the part number of the replacement part.
<Removing>
(1) Remove Chute unit (ADF paper chute), Stacker unit, PCB unit, Rear cover, Upper cover and Guide A ASSY by
referring to Sections from
4-7-1
to
4-7-6
.
(2) Remove the Dust cover by referring to
Section 4-10-3
.
(3) Loosen two screws, and remove the
Black sheet from Dust cover.
(4) Release three craws A that fix the Reflector of the lamp.
(5) Remove the Lamp SR form the Reflector.
<Mounting>
(1) Follow the removing procedure in reverse. If the glass of the Dust cover and the inside of the reflector are dirty, clean
them.
(2) Take care that the cables are routed as follows.
(3) After mounting the Lamp, perform the following adjustment:
■ White balance adjustment (
Section 5-1-5
)
■ Offset adjustment (
Section 5-1-4
)
■ Magnification adjustment (
Section 5-1-3
)
Slim cable shall be
under the thick cable
Craw A (3 locations)
Claw A
Screw fixing Black sheet
