NewFEIMAS
Refer to Revision Record on page 2.
T.Anzai
Nov. 20, 2008
K.Okada
Rev
04
03
PAGE
54
/
138
PFU LIMITED
P1PA03334-B30X/6
Refer to Revision Record on page 2.
T.Anzai
July 7, 2008
K.Okada
Refer to Revision Record on page 2.
K.Okada
K.Okada
DESCRIPTION
CHECK
DATE
T.Anzai
APPR.
K.Okada
K.Okada
Aug.19, 2005
DESIG
N
DESIG
.
CUST.
I.Fujioka
I.Fujioka
T.Anzai
CHECK
fi-5530C/fi-5530C2
IMAGE SCANNER
MAINTENANCE MANUAL
APPR.
TITLE
DRAW.
No.
Feb.23, 2007
05
Section 3-3-12
3-3-12. Error detection of “U4: ADF cover open”
Table 3-3-12
Item
No.
Check items
How/where to check
1
Does the same symptom occur after
turning OFF and ON the scanner?
Press power button of the scanner for more than 2 seconds to
turn it OFF, and after more than 2 seconds elapse, press the
power button to turn the scanner ON.
2
Is there a slip of paper left near Cover
open sensor?
Open the ADF and check inside visually.
3
Check the performance of Cover open
sensor
Conduct Maintenance mode (
Section 5-1-2
) to see if the sensor
works properly.
If the error still occurs, confirm that the cable is correctly
connected.
3-3-13. Frequent “U2: multi feed error”
Table 3-3-13
Item
No.
Check items
How/where to check
1
Do the documents satisfy paper
specification?
Refer to
Section 1-2
for paper specification, paying attention to
the following points:
•
Is multi feed error detected by paper length when scanning
documents with different length?
•
Is there perforation in the center of documents?
2
Clean ADF unit.
Refer to
Section 1-7-1
for cleaning cycle and method. Clean
Pick roller, Pad ASSY and around US sensor with care.
3
Replace Pick roller and Pad ASSY and
see if the error is resolved.
Check the consumable counter from the TWAIN driver screen
or from the built-in Maintenance mode (
Section 5-1-6
). When
the counter exceeds the values shown in
Section 1-8-1
, replace
Pick roller or Pad ASSY.
4
Check the performance of US sensor.
Conduct Maintenance mode (
Section 5-1-2
) to see if the sensor
works properly.
If the error still occurs, confirm that the cable is correctly
connected then replace the sensor. (Refer to
Section 4-9-5
,
4-10-1
)
