NewFEIMAS
Refer to Revision Record on page 2.
T.Anzai
Nov. 20, 2008
K.Okada
Rev
04
03
PAGE
107
/
138
PFU LIMITED
P1PA03334-B30X/6
Refer to Revision Record on page 2.
T.Anzai
July 7, 2008
K.Okada
Refer to Revision Record on page 2.
K.Okada
K.Okada
DESCRIPTION
CHECK
DATE
T.Anzai
APPR.
K.Okada
K.Okada
Aug.19, 2005
DESIG
N
DESIG
.
CUST.
I.Fujioka
I.Fujioka
T.Anzai
CHECK
fi-5530C/fi-5530C2
IMAGE SCANNER
MAINTENANCE MANUAL
APPR.
TITLE
DRAW.
No.
Feb.23, 2007
05
Section 5-1-6
5-1-6 Maintenance mode #5: Counter display and reset
In this mode, the following counters are displayed and reset:
•
Pick counter (Abrasion counter for Pick roller)
•
Pad counter (Abrasion counter for Pad ASSY)
•
Remaining ink counter
•
Roller kit counter for Imprinter
[How to operate]
(1) Select (Maintenance mode #5) by pressing Function button at Screen T04, and then press Scan button. The scanner
shows a number that shows the current selection of the counter type. The number indicates the counter type as follows.
Function No.
Display
Counter type
Remarks
0
Pick counter (Abrasion counter for Pick roller)
Default
1
Pad counter (Abrasion counter for Pad ASSY)
2 (Reserved)
3
Remaining Ink counter
4
Roller kit counter for Imprinter
(2) Change the selection by pressing Function button.
(3) The counter is displayed as follows when pressing Scan button.
Counter
Display
Pick counter
(Abrasion counter for Pick roller)
The counter displays 8 digits in total, 1 number at a time, from left digit to
right digit. If the counter has not reached 8 digits yet, 0 is added to blank
digits.
The symbol “-” is displayed before the first number to indicate the
beginning of counter display.
The counter displays “0” until it reaches 500, and increases the value in 10
increments after 500.
e.g. When the counter is “16,245”, “-00016245” is displayed in the
following order:
“-”
“0” “0” “0” “1” “6” “2” “4” “5”
Pad counter
(Abrasion counter for Pad ASSY)
Display method is same as Pick counter above.
Remaining Ink counter
The counter displays 3 digits in total with the unit of %. Initial is 100%,
and the value reduces as imprinter prints. Use this value as a reference,
because ink consumption may vary widely depending on the printing
condition.
Roller kit counter for Imprinter
Display method is same as Pick counter above.
When Roller kit is replaced, this counter shall be reset.
