160
Therefore, in communication mode, users can change values of
certain parameters in RAM rather than storing the setting.
● For groups P parameters, users only need to change high order
F of the function code address to 0. For groups A parameters, users
only need to change high order A of the function code address to
4.The function code addresses are expressed as follows:
● High-order bytes: 00 to 0F (groups P), 40 to 4F (groups A)
● Low-order bytes: 00 to FF
For example, if function code P3-12 is not stored into EEPROM,
the address is expressed
as 030C; if function code A0-05 is not stored into EEPROM, the
address is expressed as 4005.
It is an invalid address when being read. Users can also use
command code 07H to implement this function.
Stop/RUN Parameters
Para.
Address
Description
Address
Description
1000
*Communication setting
value
(Decimal)
-10000~10000
1010
PID setting
1001
Running frequency
1011
PID feedback
1002
Bus voltage
1012
PLC process
1003
Output voltage
1013
Pulse input frequency, unit: 0.01kHz
