- 90 -
Set
value
Function
description
18
Lower frequency
arrival
(Not output when
stopped)
When the operating frequency reaches the lower
limit frequency, the ON signal is output. In shutdown
mode, the signal is OFF.
19
Under voltage status
output
When the inverter is in the undervoltage condition,
the ON signal is output.
20
Communication
settings
Please refer to the communication protocol.
21 Keep
keep
22 keep
keep
23
Zero speed running 2
(Also output when
stopped)
When the inverter output frequency is 0, the ON
signal is output. The signal is also on in the shutdown
state
24
The accumulated
power-up time arrives
When the accumulated time (P7-13) of the inverter
exceeds the set time of P8-16, the ON signal is
output.
25
Frequency level
detection FDT2 output
Please refer to the description of function codes P8-
28 and P8-29.
26
Frequency 1 reaches
the output
Please refer to the description of function codes P8-
30 and P8-31.
27
Frequency 2 reaches
the output
Please refer to the description of function codes P8-
32 and P8-33.
28
Current 1 reaches the
output
Please refer to the description of function codes P8-
38 and P8-39.
29
Current 2 reaches the
output
Please refer to the description of function codes P8-
40 and P8-41.
30 Timed arrival output
When the timer function selection (P8-42) is valid,
the inverter will output the ON signal after the
running time reaches the set time.
31 AI1 enter the limit
When the value of analog input AI1 is greater than
P8-46 (AI1 input protection upper limit) or less than
P8-45 (AI1 input protection lower limit), the ON
signal is output.
32 Under load
When the inverter is in the under load state, the ON
signal is output.
33 Reverse run
When the inverter is running in reverse operation, the
ON signal is output
34 Zero current state
Please refer to the description of function codes P8-
28 and P8-29
35
Module temperature
arrives
The inverter module radiator temperature (P7-07)
reaches the set module temperature
When the arrival value (P8-47) is reached, the ON
signal is output
36 Software current limit
Please refer to the description of function codes P8-
36 and P8-37
