Parker AC30V Series, Product Manual

Page: 120 / 414

9-4
Setup Wizard
AC30V series Variable Speed Drive
Motor Data
Selection of the motor type, control mode and setting the motor control and process control parameters. The Validity column indicates which
parameters are shown, dependent on the control mode.
PNO Parameter Validity Comment
IM VHz IM
VECT
PMAC
Setup Motor? Select TRUE to configure the motor parameters, FALSE to skip this section
0511 Motor Type ● ● ● Selects the motor type.
0512 Control Strategy ● ● Only visible for induction motor type.
Selects between Volts/Hz and Vector Control.
1533 Control Type
●
Only visible if Vector Control is selected.
Selects between Sensorless Control, and Closed Loop Control (with encoder).
0976 Nominal Supply ● ● ● Defines the default value for the motor frequency parameters.
0457 Base Frequency ● ● The base frequency on the motor name plate
0456 Base Voltage ● ● The rated voltage on the motor name plate
0458 Motor Poles ● ● The number of motor poles. Always enter an even number.
0455 Rated Motor Current ● ● Current rating from the motor name plate.
0460 Motor Power ● ● Power rating from the motor name plate.
0459 Nameplate Speed ● ● Nominal speed from the motor name plate.
0461 Power Factor ● Power factor from the motor name plate, (often shown as φ). If this is not available
then leave this at the default value.
0555 PMAC Max Speed ● The motor’s maximum speed.
0556 PMAC Max Current ● The motor’s maximum current
0557 PMAC Rated Current ● The motor’s rated current.
0558 PMAC Rated Torque ● The motor’s rated torque
0559 PMAC Motor Poles ● The number of motor poles. Always enter an even number.
1387 PMAC Base Volt ● Rated motor rated voltage in Volt rms
0560 PMAC Back EMF Const KE ● The motor’s Back EMF line to line, rms value (Ke, Volts rms per 1000 rpm)
0561 PMAC Winding Resistance ● The motor’s resistance, line to line at 25 °C.
0562 PMAC Winding Inductance ● The motor’s inductance line to line at maximum current
0563 PMAC Torque Const KT ● Torque constant (Kt, Nm/A rms).
0564 PMAC Motor Inertia ● The motor’s inertia
0565 PMAC Therm Time Const ● The motor’s thermal time constant
0478 PMAC SVC Start Cur ● The current level during the startup procedure.
0479 PMAC SVC Start Speed ● The speed setpoint at which the speed control is switched from an open loop
mode to a closed loop mode during the startup procedure
0464
100% Speed in RPM ● ● ● This is the speed in rpm at which the motor will turn when given a speed demand
of 100%.