Made in China
Address: 1920 S. Archibald Ave.
Suite I, Ontario, CA 91761
Phone: 909.476.0900
Fax: 909.466.0130
Email: [email protected]
LEADSUN Australia Pty Ltd
LEADSUN Global Ltd
Solar Light
User Manual
AE3 SERIES
LEADSUN INC.
Address: 42 Greens Road,
Dandenong South, Victoria 3175
Phone: +61 1300 281 005
Fax: +61 3 8610 0393
Email: [email protected]
Address: NO.1 Pingdong 1st Rd,
Nanping Science & Technology
Industrial Park, Zhuhai, China 519060.
Phone: +86-756-2289712
Fax: +86-756-8682090
Email: sales@leadsunglobal. com
A3C.041-A
Troubleshooting
No. Symptoms
Troubleshooting steps
Process
1
No light at night
Check that the lamp can be manually
activated.
Refer to “Activation and Installation” section
on this user guide and run activation tests.
Check if the solar panel is blocked
from the sunlight by houses, trees and
other obstacles.
Clear obstructions or change installation
location.
Check if there is any artificial light
source(s) shining on the solar panel
during the night.
Remove the artificial light source(s) of
interference or change the installation
location.
Examine status of each component
based on the repair guide.
Replace the damaged component(s).
2
A serious shortage
of working time
Check if the solar panel is blocked
from the sunlight by houses, trees and
other obstacles.
Clear obstructions or change installation
location.
Check if the surface of the solar panel
is dusty or covered.
Clean the surface of solar panels as
detailed above.
Examine if the battery pack is
damaged as per the repair guide
instructions.
Replace damaged battery.
3
Lighting does not
follow the normal
operating mode of
turning on and off
Confirm with supplier that the correct
working mode was used.
4
Lights fail to turn
on properly when
humans approach
Check if the air temperature close to
human body temperature.
When the air temperature is close to human
temperature, motion detection may slow
down. It will return to normal after the air
temperature changes.
Check if the installation height is too
high.
It is out of motion detection range when
installation height exceeds 8m. It is
recommended to reduce the height or use
other operating modes.
Replace damaged motion sensor or
controllers.
www.leadsun.com.au
