Feature
Code
Description
Default
key
Dialling mode
#120
If you cannot dial, change this setting according to your
telephone line service.
–
Recall/Flash time
#121
The recall/flash time depends on your telephone exchange or
host PBX.
Note
• If the unit is connected via a PBX, PBX functions
(transferring a call, etc.) might not work correctly. Consult
your PBX supplier for the correct setting.
–
ADSL mode
#124
When you use a DSL/ADSL line, this feature improves the
reliability by reducing the transmission speed.
Note
• Calling charges may be higher than usual.
0
LCD display
contrast (2-line
LCD models only)
#145
To change the LCD display contrast.
3
Scale selection
#147
The selected scale will be used when measurements are shown
on the unit's display.
–
Display interval
#148
To set display interval for messages showed alternately.
1
Administrator code
#151
To change the administrator code for mode restriction settings.
When entering the new code, using 0-9.
• The default administrator code is
"
0000
"
.
Note
• It is recommended that you change this administrator code
from the default administrator code.
–
Mode restriction
#154
To activate the mode restriction. See page 136 for details.
0
Change password
#155
To change the password for feature programming via remote
operation. When entering the new code, using 0-9.
• The default password is
"
1234
"
.
Note
• It is recommended that you change this password from the
default password.
• This password is also used for feature programming via a
web browser (LAN supported models only). (
)
–
Maintenance time
#158
The unit will automatically activate for self-maintenance. Enter
the maintenance start time by using the dial keypad.
• The default time is
"
00:00
"
.
Note
• Do not activate the unit during self-maintenance.
–
3.6 Programming features: Basic
50
Operating Instructions
