ZX-GT User’s Manual
7
The following points are important to ensure safety, so make sure that they are strictly
observed.
1. Installation Environment
• Do not use the product in environments where it can be exposed to inflammable/
explosive gas.
• To secure the safety of operation and maintenance, do not install the product close to
high-voltage devices and power devices.
• Install the product in such a way that its ventilation holes are not blocked. (excluding
the connecting surface when the products are connected to each other)
• Tighten the mounting screws with a torque specified in this manual.
2. Power Supply and Wiring
• The voltage and AC power supply must be within the rated range (24 VDC +10%, -15%).
• Reverse connection of the power supply is not allowed. Connection to an AC power
supply is also not allowed.
• The output load should not be short-circuited.
• Use the power supply within the rated load.
• High-voltage lines and power lines must be wired separately from this product. Wiring
them together or placing them in the same duct may cause induction, resulting in
malfunction or damage.
• Use the product within the power supply voltage specified by this manual.
• Use a DC power supply with safety measures against high-voltage spikes (safety extra
low-voltage circuits on the secondary side).
• Use only combinations of the Sensor and Controller specified in this manual.
Controller Specifications p.133
• When connecting Controllers to each other, use only combinations of the Controllers
specified in this manual.
Connecting Controllers to each other p.37
• Connect the exclusive device (Sensor). The product might break down or malfunction
if you use a part not included in the exclusive products.
3. Other
• Do not disassemble, repair, modify, pressurize, or incinerate the product.
• Dispose of this product as industrial waste.
• Should you notice any abnormalities, immediately stop use, turn OFF the power
supply, and contact your OMRON representative.
Precautions for Safe Use
zx_gt.book Page 7 Wednesday, May 30, 2007 3:29 PM
Summary of Contents for ZX-GT -
