Omron ZX-GT -, User Manual

Page: 39 / 166

Mounting and Connecting Devices
ZX-GT User’s Manual
1
BEFORE USE
37
Connecting Controllers to Each Other
Controllers are connected to each other via a Calculating Unit.
The number of Controllers that can be connected to each other is as follows:
• When calculating Controller measured values: three Controllers
Calculation can be performed on two of these
Controllers. (One of the calculation targets
must always be CH1.)
• When multiple points are measured and are collectively output from the Interface Unit:
three Controllers or less
1
Open the Controller connector
cover by lifting and sliding it up.
2
Mount the Calculating Unit on a
DIN track.
3
Slide the Calculating Unit
and insert it into the connector on
the Controller.
4
Slide the Controller to insert it
into the connector on the
Calculating Unit.
• Provide power to all connected Controllers.
• Connect the emitter sync wires to the respective Controllers.
• Wiring the Sensor (emitter) p.29
• Wiring the Controller p.30
1
1
2
3 4
Important
zx_gt.book Page 37 Wednesday, May 30, 2007 3:29 PM