Mounting and Connecting Devices
ZX-GT User’s Manual
30
Wiring the Controller
Wiring diagram
• Use a stabilized power supply separate from other devices and power systems for the
Controller, particularly when high resolution is required.
Recommended power supply p.28
• Wire the Controller correctly. Otherwise, the Controller may be damaged. (Pay particular
attention to prevent contact between the analog output and other wires.)
• Use the blue wire (GND (0 V)) for the power supply, and the shielded wire sheath (analog
GND) together with the black wire (analog output) for analog output. Connect analog GND to
GND (0 V) even when analog output is not used.
Names and Functions
Assignments and Functions of I/O Signal Wires p.91
Cable color Name
Function
Brown
Power supply
(24 V)
This is the power supply terminal. Connect the 24 VDC power supply to
this terminal. When using a PNP type Controller, the power supply
terminal is also the common terminal for all I/O excluding analog output.
Blue
GND (0 V)
This is the power supply 0 V terminal. When using an NPN type Controller,
this terminal is also the common terminal for all I/O excluding analog output.
Co-axial
(shield)
Analog GND
Connect this cable to the input device as the GND for analog output.
Yellow
Sync output
Normally, wire this cable directly to the sync input wire and run the
Controller in the standard mode (NORM). When the Controller is run in
the high-speed mode (FAST), operation is possible without wiring this
cable. (Note that, in the high-speed mode, the Controller becomes more
susceptible to the influence of ambient light than in the standard mode.)
Power supply (24 V)
Analog output
PASS
GND (0 V)
HIGH
LOW
Bank switching input
Reset input
Timing input
Zero reset input
Sync output
4 output
terminals
4 input
terminals
Unused
Unused
Analog GND
Brown
Blue
White
Green
Gray
Co-axial (black)
Co-axial (shield)
Pink
Orange
Purple
Red
Yellow
Light blue
Black
Important
zx_gt.book Page 30 Wednesday, May 30, 2007 3:29 PM
Summary of Contents for ZX-GT -
