Omron ZX-GT -, User Manual

Page: 104 / 166

RS-232C
ZX-GT User’s Manual
102
About Communications Commands
Command/Response Format
The command/response format differs according to the RS-232C communications
specifications. [CR] has been selected prior to shipment from the factory.
When [CR] or [CR.LF(CR+LF)] is selected
< Command >
< Response >
Command data Specifies the command and parameters.
Channel No. When multiple Controllers are connected to each other, the channel
No. is specified in front of the command. (01 to 03)
The default channel No. is channel "01".
"99" can be specified to target all channels only when the
MEASURE command is issued.
Response data Stores the acquired data.
Delimiter This control code indicates the end of the data. Either CR or
CR+LF is used.
Important
Command data Delimiter
Command data Delimiter Channel No. Space #
When there is only one Controller connected
When multiple Controllers are connected to each other
Delimiter R E
Delimiter
K O
Response data Delimiter
When processing ends successfully
When processing fails
Note
zx_gt.book Page 102 Wednesday, May 30, 2007 3:29 PM