Omron ZX-GT -, User Manual

Page: 136 / 166

Specifications and External Dimensions
ZX-GT User’s Manual
134
*1: The first response time is "measurement cycle x (number of samples to average s 1) + 1 ms" max. For
the second response time onwards, the specified measurement cycle time is output.
*2: The response time in the high-speed mode (FAST) for the IC lead pitch and IC lead width judgment modes is 1
ms.
*3: Current/voltage can be switched using the switch provided on the rear of the Controller.
*4: Can be set by the analog output scaling function.
*5: The error (ERR) state is displayed when all HIGH/PASS/LOW outputs turn OFF.
*6: Normally, wire the sync output wire directly to the emitter's sync input wire and run the Controller in the
standard mode.
On an NPN type Controller, use an NPN type emitter, and on a PNP type Controller, use a PNP type emitter.
Wiring of the sync wires is not required when the Controller is run in the high-speed mode. (Note, however,
that the Controller becomes more susceptible to the influence of ambient light in this case.)
External Dimensions
ZX-GTC11/GTC41
Ambient temperature Operating: 0 to +50°C Storage: -15 to +60°C
(with no icing or condensation)
Ambient humidity Operating and storage: 35% to 85% (with no condensation)
Vibration resistance
(durability) 10 to 150 Hz Single-amplitude: 0.35 mm for 80 min each in X, Y and Z
directions
Degree of protection IEC60529 IP20
Cable length 2 m
Material Case: PBT (polybutylene terephthalate), Cover: Polycarbonate
Weight (packed state) Approx. 330 g
Accessories Instruction Sheet
Item ZX-GTC11 ZX-GTC41
51 . 5
136
16
.
9
mm
d
i
a
.
13
.
2
13 36 . 8
3
4. 2 6 4. 3 4. 2
15
.
8
16
.
8
31
.
53
0
6
Round v i ny l i nsu l ated cab l e
5 . 2 mm d i a . (19 / 0 . 08 mm d i a . ) 13 - core
standard l ength 2 m
Round v i ny l i nsu l ated cab l e
6 . 2 mm d i a . (7 / 0 . 127 mm d i a . ) 15 - core
standard l ength 0 . 1 m
11
.
7
11
.
7
4.
3
2 . 2
29
Connector
Vo l tage / Current sw i tch
(Unit: mm)
zx_gt.book Page 134 Wednesday, May 30, 2007 3:29 PM