Omron ZX-GT -, User Manual

Page: 126 / 166

RS-232C
ZX-GT User’s Manual
124
How to count edges
Set/Acquire Measured Value/Judgment Result < MEASURE command >
Acquires the measured value. Judgment results are acquired by this command only when
the measurement mode is the IC lead pitch or IC lead width judgment mode.
< Command format >
Note that the edge count method differs from that in the specified edge measurement mode.
Edge count method in the specified edge measurement mode p.57
The boundary between incident light and
interrupted beam sections is counted as an
edge.
Note, however, that when the lower edge
or upper edge of the beam is cut off, the
lower edge or bottom edge also is counted
as an edge.
Note
Beam
Received light
1
2
3
4
Edge No.
Beam
Received light
1
2
3
4
Edge No.
5
6
M E A S U R E
M
M E A S U R E
M
CR CR
CR CR
# #
or
Channel No. (fixed at 2 digits) Channel No. (fixed at 2 digits)
or
• When there is only one Controller connected
• When multiple Controllers are connected to each other
zx_gt.book Page 124 Wednesday, May 30, 2007 3:29 PM