Omron ZX-GT -, User Manual

Page: 144 / 166

Default Values ZX-GT User’s Manual
142
Default Values
The following table summarizes the default values of this Controller.
Function Default Value
Measurement cycle Standard mode (NORM)
Measurement mode Interrupted beam width measurement
Averaging number 16
Hysteresis 00.100
Hold OFF
Judgment output timing (timer) OFF
Special functions CLOSE
Zero reset memory OFF
Zero reset 00.000
Display reverse OFF
ECO mode OFF
Number of display digits 5 digits
Output scaling Voltage
Measured value 0 mm:
−
4 V
Measured value 28 mm: 4 V
Baud rate 38400
Data length 8
Stop bit 1
Parity None
Header/footer selection CR
Binary output cycle (ms) 1
Binary level (%) 25
Edge filter 7
Bank switching setting Control key operation
Bank 1
HIGH threshold 20.000
LOW threshold 10.000
Chap5.fm 142 ページ ２００７年６月６日 水曜日 午前１０時４５分