Omron ZX-GT -, User Manual

Page: 73 / 166

Setting Output Conditions
ZX-GT User’s Manual
3
FUNCTION SETTINGS
71
Correcting Analog Output Values
Discrepancies may occur between the analog output current (or voltage) values set on
the Controller and the actual measured current (or voltage) values due to the conditions
for the connected external device or other factors. The analog output correction function
can be used to correct this discrepancy. The output values are corrected by entering the
correction value for the current (or voltage) values for any two points.
Set scaling beforehand, and select current output or voltage output. Also, connect the analog
output wire to an external ammeter or voltmeter.
This section uses a current output as an example. Change the values in this example for
voltage output as necessary.
1
Select the special setting.
2
Switch to correction of analog output.
3
Set the correction value for the first point.
4
Set the correction value for the second point.
Select [SPCL].
Select [OUT] or [ALL].
Confirm the selection.
Select [A-ADJ].
Confirm the selection.
Move from one digit to another.
Change the current value.
Confirm the selection.
Move from one digit to another.
Change the current value.
Confirm the selection.
Important
SUB
SUB
SUB
SUB
zx_gt.book Page 71 Wednesday, May 30, 2007 3:29 PM