Omron ZX-GT -, User Manual

Page: 24 / 166

ZX-GT Series
ZX-GT User’s Manual
22
Controller
Connectors
Name Function
(1) Input cable This is for connecting the Sensor receiver.
(2) Voltage/Current
switch (on rear side)
This switch is for selecting voltage output or current output as the
analog output.
(default value: voltage output)
Output scaling settings are also required when switching the output.
p.68
Before operating this switch, make sure that the Controller is turned
OFF. Make sure that the load connected to "analog output wire (co-
axial) - analog GND wire" satisfies the rating of the set state
(voltage or current output) before turning the Controller ON.
Otherwise, the Controller may be damaged.
Rating of Connected Loads (I/O Circuit Diagrams) p.33
(3) Controller connector This connector is for connecting Calculating and Interface Units.
(total 2 connectors, one on each side)
(4) Output cable The output cable connects the Controller to the power supply and
external devices, such as timing sensors or PLCs.
Connector Display and Operation Panel
(1)
(2)
(3)
(4)
(1)
(2)
(3)
(4)
(5)
(6)
(7)
(8)
(9)
Ventilation holes
Voltage/Current switch
Voltage output
Current output
Important
zx_gt.book Page 22 Wednesday, May 30, 2007 3:29 PM