Omron ZX-GT -, User Manual

Page: 63 / 166

Adjusting Detection Conditions ZX-GT User’s Manual
3
FUNCTION SET
TINGS
61
Adjusting Detection Conditions
Measurement Cycle
Normally, set the measurement cycle to the standard mode [NORM].
If the high-speed mode [FAST] is set, the measurement cycle speeds up but the
Controller becomes more susceptible to the influence of ambient light.
1
Select the measurement cycle.
Setting value Description
NORM (Standard mode) This mode is for performing measurement with laser emission from
the emitter synchronized with the measurement timing of the
receiver. However, the Controller becomes more resistive to the
influence of ambient light. (default value)
Make sure that the Controller and Sensor sync wires are
connected.
FAST (High-speed
mode) This mode is for performing measurement at high speed. Note,
however, that the Controller becomes more susceptible to the
influence of ambient light.
Select [SPEED].
Change the selection.
Confirm the selection.
Important
SUB
Chap3.fm 61 ページ ２００７年６月６日 水曜日 午前１０時４５分