Basic Operations for Displaying Measurement Results
ZW-8000/7000/5000
User's Manual
47
1
Ba
si
c con
figuratio
n
Starting Up Sysmac Studio Measurement Sensor Edition
3 Operation during RUN Mode p.95
1
Start up Sysmac Studio.
2
Create a new project for the ZW.
From Category, select [Measurement Sensor]
and from Device, select [ZW] to click the [Cre-
ate] button.
If you have a previously created project, click [Open Project] to select the project.
3
Select the [Specify a sensor] radio button to
specify the IP address of the Sensor Con-
troller to be connected.
Click the [Confirm] button to confirm the infor-
mation of the Sensor Controller.
When connection with Sensor Controller is suc-
cessful, Sensor Controller information is dis-
played.
Click [OK] button, the Sensing monitor window
appears.
When connecting online for the first time
By default, the Sensor Controller has an IP address of 192.168.250.50
For the basic operations of Sysmac Studio, refer to “Sysmac Studio Version 1 Operation Manual” (W504).
Note
Note
Note
Summary of Contents for ZW-7000 Series
