Omron ZW-7000 Series, User Manual

Page: 40 / 336

Basic Operations for Displaying Measurement Results
38
ZW-8000/7000/5000
User's Manual
ZW-5000 Series
When connecting the fiber cable, mate the convex section of the fiber connector and the
groove on the sensor controller fiber adapter.
Mate the convex section of the fiber connector with the groove on the fiber adapter and turn
the threaded section clockwise while pushing in (see figure 1).
When the fiber insertion/fixing screw is not completely tightened, as is the case in the "No good" status
in figure 2 and figure 3, optic signals cannot be transmitted and correct measurement is not possible.
Always check that the system is in the "Good" status.
Connection of Calibration ROM and Sensor Controller
• Before connecting or disconnecting the Calibration ROM, make sure that the Sensor Controller's power supply is
turned OFF. The Sensor Controller may break down if the Calibration ROM is connected while the power is ON.
• Use with the Calibration ROM always connected. If the Calibration ROM is not connected, the error message
“SYSERR” is shown in the main digital and “NO.ROM” is shown in the sub digital, where measurement is not possi-
ble.
Errors Common to All Communication States p.280
• If the Calibration ROM is lost or broken, as a provisional measure, the measurement can be resumed using the
data of the previously read Calibration ROM. For the operating procedure, refer to page p.195
5-3 Recovering Calibration ROM data p.195
1
Connect the Calibration ROM to the Sensor Control-
ler, and then tighten the supplied M2 screw.
Tightening torque: 0.15 N · m max.
Fi b er connector
Fi b er a d a pter
Groove
s ection
Convex
s ection
Thre a ded
s ection
( fig u re 2 )
(
fig u re 3
)
fig u re 1
M2 s crew
C a li b r a tion ROM
ROM connector
Important