Omron Face Plate Auto-Builder for NS 3.1, Operation Manual

Page: 42 / 143

27
Created Screens Section 5-1
Screen Building
Order (Screen
Number Order)
Control Screens are built first, followed by Tuning Screens, as shown in the
following table. Building starts from the screen number specified as the screen
number offset, and continues in sequence without skipping any screen num-
bers. (The screen number offset can be specified between 0 and 3,799 (Sys-
tem Version 2), 0 and 3,599 (System Version 4 or later). The default is 0.)
Note In the screens built using the Face Plate Auto-Builder for NS, the face plates
(in both Control Screens and Tuning Screens) are built in groups. Parts other
than face plates are not grouped.
Screen Details
A
Control Screens
(up to 8 screens)
Up to 100 face plates for system version 4 or later and up to
32 face plates for other system versions are built for the func-
tion blocks to be converted that are detected when searched
from the beginning of the CSV tag file.
The function blocks detected first are built with the smaller
numbers at the left of the screen, and are arranged in order to
the right. Six face plates are created for NS12 PTs and four
face plates are created for the NS10 and NS7 PTs, after which
building is shifted to the next screen.
The Control Screens are built for all the function blocks.
B
Tuning Screens
(up to 32 screens)
Up to100 face plates for system version 4 or later and up to 32
face plates for other system versions are built sequentially for
the function blocks to be converted that are detected when
searched from the beginning of the CSV tag file. The Tuning
Screens are built for all the function blocks.