Omron Face Plate Auto-Builder for NS 3.1, Operation Manual

Page: 120 / 143

105
Blended PID (Block Model 013) Section 6-17
6-17-2 Tuning Screens
This section describes only the differences between the tuning screens in the
Blended PID Block and Basic PID Block (Block Model 011). For details on the
areas not covered here, refer to
6-1-2 Tuning Screens .
1: Parameter Settings
These fields are used to display and set each parameter for blended PID con-
trol.
Numeral Display and Input objects are used to create these fields, and a ten-
key pad is displayed when a field is touched.
The following table shows the upper and lower limits of the setting ranges.
Parameter Referenced tag ITEM
Cumulative deviation output DEV_Q (044)
Ratio K1 (027)
Accumulated value Rightmost 4 digits: Q1 (012)
Leftmost 4 digits: Q2 (013)
(The addresses set in the object are working
addresses.)
Proportional band P (054)
Integral time I (055)
Differential time D (056)
MH (High MV limit) MH_LMT (076)
ML (Low MV limit) ML_LMT (077)
MV index position MV_IDX (098)
Parameter Lower limit Upper limit
Cumulative deviation output
−
32000 32,000
Ratio 0 3.2000
Accumulated value (Cannot be input.) (Cannot be input.)
Proportional band 0.1 999.9
Integral time 0 9999
1
2