Omron Face Plate Auto-Builder for NS 3.1, Operation Manual

Page: 111 / 143

96
Reversible Motor Manipulator (Block Model 223) Section 6-15
The overlapping button's settings are as follows:
The label displays “OFF” in the rough font.
By setting the following Touch OFF Timing macro when tag ITEM S1 = 1, the
message “Could not set.” will be displayed and the setting will not be accepted
if the button is touched when tag ITEM S1 = 1.
MSGBOX("Could not set.","OFF operation",0);
RETURN(1);
endif;
Set tag ITEM S1 as an indirect specification for the control flag input enable
and display/hide settings for this overlapping object.
The button input is also prohibited when S7 = 1, just like S1. To display a fixed
yellow button, a momentary ON/OFF Button is created using a Simple Rect-
angle (Type 2) and placed over the “OFF” button described above. This over-
lapping button is displayed/hidden according to the status of tag ITEM S7.
The overlapping button's settings are as follows:
The label displays “OFF” in the rough font.
By setting the following Touch OFF Timing macro when tag ITEM S7 = 1, the
message “Could not set.” will be displayed and the setting will not be accepted
if the button is touched when tag ITEM S7 = 1.
MSGBOX("Could not set.","OFF operation",0);
RETURN(1);
endif;
Set tag ITEM S7 as an indirect specification for the control flag input enable
and display/hide settings for this overlapping object.
3: REV Operation Button
This manipulation command button manually drives the motor in the reverse
direction and is enabled only when manual mode is selected.
This button is created as a momentary ON/OFF Button using a Simple Rect-
angle (Type 3) and the display color is determined according to the following
table.
Display color S1: A/M switch input (086)
Red 0
Yellow 1
Display color S7: Control Site Input (085)
Red 0
Yellow 1
Display color S1: A/M Switch Input (086) S6: MAN-REV (016)
Yellow 0 0
Red 0 1