Omron Face Plate Auto-Builder for NS 3.1, Operation Manual

Page: 88 / 143

73
Ratio Setting (Block Model 033) Section 6-9
3: Parameters
The Indication and Setting Block does not provide parameter settings.
4: Realtime trend
The Indication and Setting Block displays a graph for PV only.
The following screen is a Tuning Screen for an Indication and Setting face
plate built using the Face Plate Auto-Builder for NS in a 640
×
480 screen reso-
lution.
The display and operation of each object in the face plate is the same as the
version for 800
×
600 screen resolution.
6-9 Ratio Setting (Block Model 033)
This section describes only the differences between the Ratio Setting Block
and Basic PID Block (Block Model 011). For details on the areas not covered
here, refer to
6-1 Basic PID (Block Model 011) .
6-9-1 Face Plates
The Ratio Setting Block is used to set the ratio and bias and has PV-indicating
and ratio-setting functions.
1: Alarm Status Display
Unlike the Basic PID Block, this block does not output any of the high/low PV
alarms or the MV output's deviation alarm.
1
3
2