Omron Face Plate Auto-Builder for NS 3.1, Operation Manual

Page: 96 / 143

81
Timer (Block Model 205) Section 6-11
Data is written to the write address of tag ITEM PRS (ITEM 008) using the
Before Writing Numeral/String macro.
$W2047=GETNUMVAL();
WRITECMEM([PRS],$W2047,1);
RETURN(1);
The upper and lower limits are 0.0 to 3200.0.
5: SET Bit Lamp Display
A Bit Lamp indicates when the SV has been reached, as shown in the follow-
ing table.
6: PRSET Bit Lamp Display
A Bit Lamp indicates when the prediction value has been reached, as shown
in the following table.
7: START Button
When this button is touched, the write address of tag ITEM S1 (ITEM 011) is
set to 1. The value of tag ITEM S1 (ITEM 011) is referenced to set the display
color, as shown in the following table.
The button is built as a momentary ON/OFF Button using a Simple Rectangle
(Type 2). The write address is not set, and the read address for tag ITEM S1
(ITEM 011) is set as display address 1. The label displays “START” in the
rough font.
The following macro is set as a Touch OFF Timing macro, and when touched,
the fixed value 1 is written to the write address of tag ITEM S1 (ITEM 011).
$B32766=1;
WRITECMEM([S1],$B32766,1);
8: STOP Button
When this button is touched, the write address of tag ITEM S1 (ITEM 011) is
set to 0. The value of tag ITEM S1 (ITEM 011) is referenced to set the display
color, as shown in the following table.
Display color U1 (013)
Green 0
Red 1
Display color U2 (014)
Green 0
Red 1
Display color S1 (011)
Yellow 0
Red 1
Display color S1 (011)
Red 0
Yellow 1