Omron Face Plate Auto-Builder for NS 3.1, Operation Manual

Page: 91 / 143

76
Ratio Setting (Block Model 033) Section 6-9
Numeral Display and Input objects are used to create these fields, and a ten-
key pad is displayed when a field is touched.
The following table shows the upper and lower limits of the setting ranges.
The following table shows the units that are displayed. These units are fixed.
The following values are used in communications with the PLC.
Data is written to the write address of each tag ITEM using a Before Writing
Numeral/String macro, as follows:
$W2047=GETNUMVAL();
WRITECMEM([K1/A1/B1/MH_LMT/ML_LMT/MV_IDX],$W2047,1);
The following screen is a Tuning Screen for a Ratio Setting face plate built
using the Face Plate Auto-Builder for NS in a 640
×
480 screen resolution.
ML (Low MV limit) ML_LMT(ITEM077)
MV index position MV_IDX(098)
Parameter Lower limit Upper limit
Ratio range
−
10.000 10.000
Input bias
−
320.00 320.00
Output bias
−
320.00 320.00
MH (High MV limit)
−
320.00 320.00
ML (Low MV limit)
−
320.00 320.00
MV index position
−
15.00 115.00
Parameter Unit
Ratio range None
Input bias %
Output bias %
MH (High MV limit) %
ML (Low MV limit) %
MV index position %
Parameter Values used in PLC device/communications
Ratio range
−
10,000 to 10,000 (Displayed value
×
1,000)
Input bias Percent data
Output bias Percent data
MH (High MV limit) Percent data
ML (Low MV limit) Percent data
MV index position Percent data
Parameter Tag ITEM