Omron Face Plate Auto-Builder for NS 3.1, Operation Manual

Page: 116 / 143

101
Motor Opening Manipulator (Block Model 224) Section 6-16
7: Close Manipulation Output Display
A lamp indicates the status of the close manipulation output and the lamp is
red when the output is ON.
The bit lamp is set as a round single-line lamp with the following display col-
ors.
The label displays “LO” in the rough font.
8: Thermal Relay Display
This lamp indicates when both the thermal relay open input and thermal relay
close input are OFF. The lamp is red when both inputs are OFF.
This lamp is created as a momentary ON/OFF Button using a Simple Rectan-
gle (Type 3) and the display color is determined according to the following
table.
The label displays “Thermal” in the rough font.
9: Tuning Screen Button
The Motor Opening Manipulator face plate does not provide a Tuning Screen
Button.
The following diagram shows a High/Low Alarm face plate built using the Face
Plate Auto-Builder for NS in a 640
×
480 screen resolution.
Display color U2: Close manipulation
output (022)
Green 0
Red 1
Display color S3: Thermal relay open
input (019)
S4: Thermal relay close
input (020)
Red 0 0
Green 0 1
Green 1 0
Green 1 1