Omron Face Plate Auto-Builder for NS 3.1, Operation Manual

Page: 33 / 143

18
Basic Operation Section 4-1
Refer to 5-4 Engineering Units for details on unit and scale settings.
Comments are automatically entered for unit and scaling settings automati-
cally allocated by the Face Plate Auto-Builder for NS. Unit and scaling settings
for which comments have been automatically entered are automatically gen-
erated by the Face Plate Auto-Builder for NS; do not change the settings
when constructing screens.
Data Log Number Offset
Specify the first number allocated to the data log group in the NS-series PT.
The maximum value of the data log used by the Face Plate Auto-Builder for
NS is 100 for NS system version 4 and higher and 32 for other versions.
One is allocated for each
registered function block
(DV scaling settings).
The total number of freely set values for
bank data registered for Segment Program 3
(only in version 6.6 and NS-Runtime).
These 100 are allocated regardless
of the number of registered
function blocks
Allocation of Unit and Scaling Settings
Start of unit and scaling
settings to be set (default: 12)
These 100 are allocated regardless
of the number of registered
function blocks
Two allocated for Segment
Program 2. Numbers 999 and
1000 are always allocated
regardless of the start number
setting. (Applies only when the
detailed setting screen of
Segment Program 2 is used.)
The NS System uses
the first 11.
Five are always
allocated.
One is allocated for each
registered function block
(PV scaling settings).