Chapter 9: IP65 Option Considerations
1. Remove the red shipping plug from the compressed air fitting on the top of the robot.
Figure 9-3. Compressed Air Inlet Port - 3/8 inch NPT Female fitting (A) and Hugh Flow-Low Vacuum
Port - 3/4 Inch NPT Female Fitting (B)
2. Connect a compressed air source to the air fitting. The specification for the regulated air
supply is shown in the following table.
Table 9-1. Compressed Air Specifications
Required Air Pressure
Required Air Flow, Minimum
3 bar, ±10%
(44 PSI, ±10%)
57 liters per minute
(2 cubic feet per minute)
!
CAUTION: PROPERTY DAMAGE RISK
The compressed air supply must be clean and dry and it must be turned on
continuously to maintain a positive air pressure inside the robot. Failure to do
this could result in moisture or particle buildup inside the robot, lead to
reduced performance or damage to the robot, and could void your warranty.
24402-000 Rev B
eCobra 600 and 800 Robots with EtherCAT
155
