Omega RD-MV100 Series, User Manual

Page: 149 / 299

7-15
Setting and Operating the Display
7
7.10 Setting the Scale Division, Bar Graph Base
Position (Bar Graph), and Scale Position
(Trend)
• The scale used on trend and bar graphs can be set.
• When the bar graph is displayed horizontally, the base position of the bar graph can
be set on each channel by selecting either [normal] or [center].
Normal : The left edge or the right edge of the display span depending on which value
is smaller.
Center : Position at 50% of the display span
For the procedures to set the vertical or horizontal display, see section 7.13.
• The scale display position for each channel can be specified on the trend display.
Procedure
• These procedures are carried out in the setting mode.
• Use the arrow keys to move the cursor (blue) to the appropriate parameter. (The
parameters that cannot be changed are grayed.)
• The possible selections are displayed at the bottom of the screen. Select using the
soft keys.
• The parameter boxes that are changed are displayed in yellow. By confirming the
new settings, they change back to white.
Press MENU .
Press the soft key
Next 1/3
.
Press the soft key
#5
.
Setting on a measurement channel
To display the setting screen press the soft key
#3
.
Setting on a computation channel (option)
To display the setting screen press the soft key
#6
.
1
2
3
4
The numbers in front of the operating procedure shown below correspond to the
numbers in the above figure.
1. First channel and last channel
Select the desired channels. (For the channels set here, [Zone] and [Partial] are
also simultaneously set.)