Omega RD-MV100 Series, User Manual

Page: 261 / 299

13-2
13.2 Replacing the Fuse
Don’t replace the fuses for 100-120 VCA/200-240 VCA power supply models by yourself.
For replacement, please, contact Omega.
Replace the fuse every two years for preventive maintenance.
For 12 VDC Power Supply Model
WARNING
• For safety reasons, make sure to turn OFF the power switch and disconnect the
recorder from the main power supply before replacing the fuse.
• To prevent the possibility of fire, use only the specified fuse purchased from
Omega.
• Never short circuit the fuse holder to bypass the use of a fuse.
Follow the procedures below to replace the fuse of the 12 VDC power supply model.
For fuse rating, see section 13.4 “Recommended Replacement Periods for Worn Parts.”
Follow the procedures below to replace the fuse.
1. Turn OFF the power switch.
2. Disconnect the recorder from the main power supply.
3. While pressing the fuse carrier located to the right of the power switch, turn it
counter-clockwise approximately 45 degrees. The carrier and the fuse will slide
out.
4. Replace with a new fuse, insert the carrier in the fuse holder, and turn it
clockwise while pressing the carrier to fix it in place.
For 100-120 VAC/200-240 VAC Power Supply Model
WARNING
• Don’t replace the fuse by yourself. Never take RD-MV100 part to replace a
fuse.
Fuse ratings
Rated voltage: 250 V
Rated current: 1 A
Type: Time lag
Approved standard: IEC/VDE