Omega RD-MV100 Series, User Manual

Page: 57 / 299

2-11
Before Using the Recorder
2
2.6 Remote Control Wiring (/R1, Option)
WARNING
To prevent electric shock, ensure the main power supply is turned OFF.
Wiring Procedure
1. Turn OFF the recorder and remove the cover for the option terminal.
2. Connect the remote control signal wires to the terminal.
The terminal arrangement for the remote control option is as follows. C is a
common terminal for terminals 1 through 8.
Terminal position
Option terminal
Terminal arrangement (only the position of the remote control terminals is
indicated.)
“C” denotes the
common terminal.
3. Replace the terminal cover and fasten it with screws.
Note
• The option terminal block itself can be removed by loosening the two screws at the top left
and bottom right of the terminal block. This makes wiring work easier. To prevent bad
contacts, make sure to securely tighten the screws after wiring.
• Use shielded wires for the remote control wires to reduce the effects of noise. Connect the
shield to the earth ground terminal of the recorder.