Nortel Observe, User Manual

Page: 139 / 143

Nortel Proprietary
10
11
12
13
14
15
DATE 7 OCT 2003
Figure 50
Printing TUI port Switch Configuration in overlay 20
4. From Overlay 32, disable all ports in the Nortel Remote Agent Observe slot.
Command Description
DISC l s c Disable the pre-configured card.
Figure 51
Disabling the Nortel Remote Agent Observe Card slot using overlay 32
5. From Overlay 11, remove all TUI ports in the Nortel Remote Agent Observe slot. i.e. All
even ports that are configured – 0,2,4,6 etc…
Prompt Response Description
REQ: OUT Remove pre-configured port
TYPE: 2616 M2616 port
TN l s c u Terminal Number.
Figure 52
Removing TUI ports using overlay 11
6. When all TUI ports have been removed, enter overlay 20 and search for all unused DNs on
the switch.
Prompt Response Description
REQ: PRT Print
TYPE: LUDN List of Unused DNs
CUST: 0-99 Customer Number
Figure 53
Displaying a list of unused DNs in overlay 20
7. From the list of unused DNs, chose a DN for each TUI port to be re-configured. I.e. if you
have 4 TUI ports, choose 4 DNs, 8 TUI ports then choose 8 DNs etc... In the “Switch
Configuration Chart”, enter in the chosen DNs into the “SCR DN” column for each TUI
port configured.
8. In the “Switch Configuration Chart”, there exists a “HUNT DN” column.
The Hunt DN is used to link all the SCR key DNs together in a chain.
•
For each TUI Port, the Hunt DN should equal the SCR key DN of the next
configured TUI port.
Planning, Installation and Administration Guide
139
Note:
To allow observers to dial into the Nortel Remote Agent Observe TUI using
the same number as previously used, set the SCR DN for TUI port 0 equal to
the MCR key DN used previously.