Nitto DURA SI600, Instruction Manual

Page: 4 / 175

PREFACE
II
IMPORTANT INFORMATION

This product has potential dangers. Please install, operate and maintain/examine
the product in accordance with the instructions in this manual.

If you do not follow the instructions, or if any harm or injury occurs caused by
carelessness, misuse/unpermitted modification or other action, NITTO DENKO takes
no responsibility.
 In the industrial device industry, as new materials, processing methods as well as acceleration of the
mechanical devices, more and more potential dangers show up. These dangers could not be predicted
under all circumstances. Moreover, “things that cannot be done” and “things that mustn’t be done” exist
in large amount, which is not possibly to be all listed in this manual. If it is NOT indicated in the
manual as “things that can be done”, please regard it as “things that cannot be done”. During the
installation, operation and/or maintenance/examination of this product, please give full consideration to
not only those points written in this manual and/or indicated on the main part of the product, but also
general safety measures.

A blade used to cut label off is set in the optional Cutter Unit. If you put your finger tips close to this
part, pinching or cutoff injuries will happen. When you fasten or remove the Cutter Unit, please set the
power switch as OFF.

In order to prevent potential trouble or malfunction, please keep regular maintenance.
Refer to “4.1 Cleaning the Interior of the Printer” described in chapter 4 of the manual.
 The copyright of this manual belongs to NITTO DENKO and NITTO DENKO keeps all rights. Please
do not duplicate or publicize any picture and/or technical data without a previous written consent from
NITTO DENKO.
 If you have any question about this manual or you need more detailed information, please go to the shop
you purchased this product or our customer window for enquiry and bring with you the type (model)
and serial number indicated on the plate, and please do not proceed with your operation before you ask
your questions and receive the answer.
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and receiver.

Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.

Consult the dealer or an experienced radio/TV technician for help.