Nitto DURA SI600, Instruction Manual

Page: 146 / 175

MAINTENANCE
4-8
4.2 Replacing the Thermal Head
This section is an explanation of how to replace the Thermal Head.
1
Press on the [

] side of the
Power Switch and power is
turned OFF.
Power Lamp goes out, and the power source
is disconnected.
2
Open the Side Cover.
3
Pull the Head Lock Lever
upwards and towards available
directions.
The Thermal Head is lifted.
4
Remove the thermal transfer
ribbon.
When opening the
side cover, please
open it completely
untill the top surface of
the cover touches the
printer main part. If you
release your hands
when the cover is half
open or in the midway
of opening/closing it,
the cover might fall
and result in injury
and/or malfunction.
If heat-sensitive label is
used, please proceed
with the following steps.
When handling the
Head Lock Lever,
please do not put your
fingers and/or hands
near the tuning area
of thermal head. It
might cause injury