Nitto DURA SI600, Instruction Manual

Page: 150 / 175

MAINTENANCE
4-12
4.3 Replacement of Platen Roller
This section is an explanation of how to replace Platen Roller.
1
Press on the [

] side of the
Power Switch and power is
turned OFF.
Power Lamp goes out, and the power source
is disconnected.
2
Open the Side Cover.
3
Pull the Head Lock Lever
upwards and towards available
directions.
The Thermal Head is lifted.
4
Remove the thermal transfer
ribbon.
When opening the
side cover, please
open it completely
untill the top surface
of the cover touches
the printer main part.
If you release your
hands
when the
cover is half open or
in the midway of
opening/closing it, the
cover might fall and
result in injury and/or
malfunction.
For details about how to
remove the thermal ribbon,
please read the steps 4 to 5
of “1.4.1 Installing the
Thermal Transfer Ribbon”
on page 1-10.
If heat-sensitive label is
used, please proceed with
the following steps.
When handling the
Head Lock Lever,
please do not put
your fingers and/or
hands near the tuning
area of thermal head.
It might cause injury.