Nachi RMU20-20, Instruction Manual

Page: 84 / 190

3.2Operation procedure
3-14
2 Press the f key “Form Limit”.
>>The “Form Limit” Setting screen shown below will appear.
*”Offset” of the forms represents distances from the
distances from the tool
installation flange , respectively.
3 Press the f key “Sphere Limit”.
>>Each time when the f key “Sphere Limit” and the f key “Form Limit” are pressed, the
“Sphere Limit” and “Form Limit” screens are alternately switched.
4 Press the f key “Tool Number”.
>>The following window will appear.
5 Enter the desired "Tool No."
>> The displayed No. on the f key will be changed.
6 Press the f key “Page” key.
>>The Sphere Limit Setting screen will be switched.
*This screen is only displayed while in sphere limit mode.