Motorola DIMETRA MTS 2, Installation, Configuration And Basic Service Manual

Page: 211 / 517

MTS 2 and MTS 4 Installation, Con
fi
guration and Basic Service Manual Test Equipment
The MTS Site Controller has the following modes of operation:
•
BOOT1 - to access this mode, interrupt the booting process by pressing the
ESC
key or
Ctrl+C
combination when the appropriate message appears. A
password may be required to enter this mode.
•
Test Application - to access this mode, type the
testapp
command when in the BOOT1
mode. To return to the normal Site Controller Application, type
reset -oplatform
command. This action reboots and resumes the normal operation.
•
Site Controller Application - if the boot process is not interrupted, this
is the default mode of operation.
The MTS Base Radio has the following modes of operation:
•
BOOT1 - to access this mode, interrupt the booting process by pressing the
ESC
key or
Ctrl+C
combination when appropriate message appears. A password may be required to enter this mode.
•
Test Application - to access this mode, type the
testapp
command when in BOOT1
mode. To return to the normal Base Radio Application, type
reset -oplatform
command. This action reboots and resumes the normal operation.
•
Base Radio Application - if the boot process is not interrupted, this is
the default mode of operation.
Each of these modes contains a different set of Man Machine Interface Commands, which
are described in the “MTS Interface Commands” booklet.
The Test Application mode is a powerful mode. Inappropriate use of
the Test Application MMI can lead to a permanent hardware failure.
Please proceed with extreme caution.
Test Equipment
Table 6-1 lists the recommended test equipment for the Equipment Cabinet proce-
dures. Equivalent equipment is acceptable.
Ensure that the test equipment is connected to the same ground system as the
equipment under test before any other connections are made to the test equipment.
6802800U74-N September 2009
6-3