Motorola DIMETRA MTS 2, Installation, Configuration And Basic Service Manual

Page: 49 / 517

MTS 2 and MTS 4 Installation, Con
fi
guration and Basic Service Manual General Safety
Some commands executed during Conformance Testing will bypass
normally available alarms and protection associated with the normal MTS
operation. Therefore, it is imperative to adhere to all cautionary information
and follow instructions exactly as in the procedures.
The MTS site must meet certain specifications for adequate protection
from lightning induced transients. Proper ground installation methods are
outlined in the Motorola Standards and Guidelines for Communications
Sites, R56 manual. Refer to Quality Standards in Chapter 1 - Overview
for information on obtaining the R56 manual.
The Site Controller motherboard contains a lithium battery. Refer to local
regulatory requirements for proper disposal of the battery.
Any device (for example, power supply) providing isolation between the mains
and the MTS must provide reinforced insulation to hazardous voltages. The
DC power source providing power to the MTS shall comply with requirements
specified for a safety extra low voltage circuit (SELV) per EN60950.
Always use appropriate equipment and number of personnel whenever moving
an MTS equipment cabinet to reduce the risk of injury.
This MTS Service Manual is intended for trained technicians experienced with
Motorola Base Radio equipment or similar types of equipment.
Use extreme caution when wearing a conductive wrist strap near sources of high
voltage. The low impedance provided by the wrist strap also increases the danger
of lethal shock should accidental contact with high voltage sources occur.
6802800U74-N September 2009
2-3