Motorola DIMETRA MTS 2, Installation, Configuration And Basic Service Manual

Page: 403 / 517

MTS 2 and MTS 4 Installation, Con
fi
guration and Basic Service Manual Base Radio Alarms
Table 13-7 Generic Base Radio Alarms (Continued)
Alarm ID Description
Recovery
Action
Clear Action Notes
mand can be used for
checking the thresh-
old that is currently
used. The alarm may
be reported because
of the BRC hardware
failure or con
fi
gura-
tion problems.
ALM_RX2_PATH
RSSI for
Receiver path
2 is much
lower than
maximal RSSI
measured for
the remaining
con
fi
gured
paths.
No recovery
action taken by
the software.
When the clear
condition is met
then the alarm is
cleared. Each time when RSSI
for path 2 is less than
(max_RSSI - mts_re-
ceive_path_thresh-
old) then RSSI failure
counter for path 2
is incremented by 1.
Otherwise the counter
is decremented by 2.
After checking the
alarm condition the
counter is set to 0 if it
has a negative value.
The ’rssicnt’ com-
mand can be used for
checking the thresh-
old that is currently
used. The alarm may
be reported because
of the BRC hardware
failure or con
fi
gura-
tion problems.
ALM_RX3_PATH RSSI for
Receiver path
3 is much
lower than
maximal RSSI
measured for
the remaining
con
fi
gured
paths.
No recovery
action taken by
the software. When the clear
condition is met
then the alarm is
cleared. Each time when RSSI
for path 3 is less than
(max_RSSI - mts_re-
ceive_path_thresh-
old) then RSSI failure
counter for path 3
is incremented by 1.
Otherwise the counter
is decremented by 2.
After checking the
alarm condition the
counter is set to 0 if it
has a negative value.
The ’rssicnt’ com-
mand can be used for
checking the thresh-
old that is currently
used. The alarm may
be reported because
6802800U74-N September 2009
13-37