Motorola DIMETRA MTS 2, Installation, Configuration And Basic Service Manual

Page: 465 / 517

MTS 2 and MTS 4 Installation, Con
fi
guration and Basic Service Manual How to Install
Process 15-4 Installing 4 CH Cavity Combiner Expansion Kit
1
Install the new Cavity Combiner into the cabinet, see Procedure 15-10, "How to Install
Additional Cavity Combiner," on page 15-35 .
2
Update the mapping list with the new unit TrackID, see Procedure 7-15, "How to Update the
Mapping List with the New TrackerID," on page 7-28 .
The cavity Combiner can weigh up to 11.8 kg (26 lbs.). Use caution when
removing or installing Cavity Combiner into the equipment rack. Make
sure the combiner is fully supported when free from mounting rails to
avoid injury to personnel and equipment damage.
Figure 15-14 ATCC Cabling Diagram for MTS 4 with 1 TX ant. before Expansion
Procedure 15-10 How to Install Additional Cavity Combiner
1
Only applies for Auto Tuned Cavity Combiner (ATCC).
Switch OFF the Power Supply Unit.
2
Remove the panel in front of where the additional Cavity Combiner is to be assembled.
3
Assemble bracket with 3 M6x10 screws.
6802800U74-N September 2009
15-35