Motorola DIMETRA MTS 2, Installation, Configuration And Basic Service Manual

Page: 110 / 517

MTS LVD Kit Installation Chapter 4: Hardware Installation
Procedure 4-9 How to Install the MTS LVD Kit (Continued)
4
Flip the backplate by hand, and insert the 2 rivet plugs as in Figure below.
Figure 4-34 MTS LVD Kit Backplate Plugs
5
Mount the LVD housing to the intended location, i.e. on top of the MTS as shown in Figure
below, using a hammer for snapping in the screw.
Figure 4-35 Mounting the MTS LVD Kit
The plug
fi
ts into any Ø7mm hole. Center diameter between the two rivet plugs
is 90mm
6
Locate the Power connector on the Site Controller and disconnect this.
7
Plug the LVD controller cable into the now empty power slot and plug the existing power plug
just removed in step above into the empty socket on the controller cable.
8
Secure LVD controller cable using cable ties to the best possible routing toward the LVD relay.
Avoid any potential damages on cable due to sharp edges etc.
9
Switch power ON.
10
Check if the relay is engaged, when MTS 4 is powered up.
4-34
6802800U74-N September 2009