Motorola DIMETRA MTS 2, Installation, Configuration And Basic Service Manual

Page: 460 / 517

Con
fi
guring Redundant Site Controller Chapter 15: Expansion Options
Process 15-3 How to Configure Redundant Site Controllers
1
Perform Site Controller Hardware Pre-Checks, as described in Procedure 15-6, "Site Controller
Hardware Pre-Checks," on page 15-30 .
2
Con
fi
gure the Site Controller Con
fi
guration Files, see Procedure 15-7, "Site Controller
Con
fi
guration Files," on page 15-30 .
3
Con
fi
gure Ethernet ports connecting the two Site Controllers, as described in Procedure 15-8,
"Con
fi
gure Ethernet Ports," on page 15-31 .
4
Con
fi
gure the ID values of the Site Controllers, see Procedure 15-9, "Con
fi
gure Site Controller
IDs," on page 15-32 .
Procedure 15-6 Site Controller Hardware Pre-Checks
1
Ensure that both Site Controllers are correctly installed and are running identical software
applications, Boot images and con
fi
guration
fi
les.
2
In order for the Redundant Site Controller feature to work correctly, the Site Controller and
BR Boot1 version must be:
•
TSC_RLJ_BOOT1–R06.40.07 or later for SC.
•
BRC_RLJ_BOOT1–R06.40.05 or later for Base Radio.
The Boot1 version can be checked on the Site Controller and BRs by resetting the
Site Controller/BR and interrupting the startup sequence when prompted to go into
Boot1 mode. The software version is displayed when entering Boot1 mode.
3
Check that the redundant Site Controller Ethernet Link cables are connected correctly, as shown
in
Figure 15-11 .
4
Proceed to Procedure 15-7 below.
Procedure 15-7 Site Controller Configuration Files
In order to check that the Site Controller con
fi
guration
fi
les have the Standby Site
Controller Installed parameter enabled, follow the steps below.
1
Log onto the Site Controller Application MMI.
2
From the SC: prompt, run the command
display config
.
3
Check the output of the con
fi
guration and con
fi
rm if the Standby Site Controller parameter is
enabled or not.
4
If no Standby Site Controller is enabled, upload the Active Site Controller con
fi
guration
fi
le.
5
Modify the con
fi
guration
fi
le in TESS to enable Standby Site Controller.
15-30
6802800U74-N September 2009