Motorola DIMETRA MTS 2, Installation, Configuration And Basic Service Manual

Page: 227 / 517

MTS 2 and MTS 4 Installation, Con
fi
guration and Basic Service Manual Base Radio Receiver Con
fi
guration
Base Radio Receiver Configuration
The procedure below can be done locally as well as remotely. The commands to check and
change the BR parameters require the use of BRC Application MMI.
Procedure 6-3 How to Verify Base Radio Parameters
1
Log in to the Base Radio in application mode.
2
Type
get nvm_param rx1 atten_default
and press
Enter
.
Result: The correct setting should be
0
for MTS 4 and
4
for MTS 2.
If no returned parameter value is observed then the parameter is missing. See Table 6-7 to add
the parameter.
3
Type
get nvm_param pa dekey_limit
and press
Enter
.
Result: The correct setting should be
6
.
If no returned parameter value is observed then the parameter is missing. See Table 6-7 to add
the parameter.
4
Type
get nvm_param rx1 rx_dc_inj_usl
and press
Enter
.
Result: The correct setting should be
1.5
.
If no returned parameter value is observed then the parameter is missing. See Table 6-7 to add
the parameter.
5
Type
get nvm_param rx1 rx_dc_inj_lsl
and press
Enter
.
Result: The correct setting should be
0
.
6
Type
get nvm_param rx1 ad1_scaling6
and press
Enter
.
Result: The correct setting should be
28.9
.
If no returned parameter value is observed then the parameter is missing. See Table 6-7 to add
the parameter.
7
Type
get nvm_param rx1 rx_fru_config
and press
Enter
.
Result: The setting will depend on the receiver diversity required for the site.
If no returned parameter value is observed then the parameter is missing. See Table 6-7 to add
the parameter.
6802800U74-N September 2009
6-19