Mitsubishi MOTORS OUTLANDER PHEV 2021, Owner'S Manual

Page: 285 / 403

Blind Spot Warning (BSW) (with Lane Change Assist)*
7-82 Starting and driving
7
E00652300429
When the BSW switch is pressed while the
operation mode is ON, the BSW indicator
lamp in the instrument cluster comes on and
the BSW becomes in stand by state. When the
BSW switch is pressed again, the BSW indi-
cator lamp in the instrument cluster goes off
and the BSW turns off.
Indicator lamp
If you turn the BSW ON/OFF, the Rear Cross
Traffic Alert (RCTA) also turns ON/OFF at
the same time.
• When the sensor is extremely hot or cold
(while the vehicle is parked for a long
period of time under a blazing sun or in
cold weather).
• When a bicycle carrier or accessory is
installed to the rear of the vehicle.
CAUTION
 To maintain proper performance of the BSW,
follow the instructions below.
• Always keep the bumper surface around the
sensor clean.
• Avoid impacting the sensor or its surround-
ing area.
• Do not put a sticker on the sensor or its sur-
rounding bumper surface.
• Do not paint the sensor or its surrounding
bumper surface.
• Do not modify the sensor or its surrounding
area.
 If the bumper has experienced an impact, the
sensor may have been damaged and the BSW
may not function properly. Have the vehicle
inspected at a MITSUBISHI MOTORS
Authorised Service Point.
WARNING To operate NOTE
 When the operation mode is set to OFF, the
selected condition just before setting to OFF
is retained.
 The BSW operates when all of the following
conditions are met.
• The operation mode is put in ON.
• The select position is in positions other than
“P” (PARK) and “R” (REVERSE).
• The speed of your vehicle is approximately
10 km/h or higher.