Mitsubishi MOTORS OUTLANDER PHEV 2021, Owner'S Manual

Page: 384 / 403

Replacement of lamp bulbs
Maintenance 11-21
11
4. Insert a new fuse of the same capacity by
using the fuse puller into the same place
in the fuse block.
E01003102004
Before replacing a bulb, ensure the lamp is
off. Do not touch the glass part of the new
bulb with your bare fingers; the skin oil left
on the glass will evaporate when the bulb gets
hot and the vapour will condense on the
reflector and dim the surface.
B- Fuse is OK
C- Blown fuse
NOTE
 If any system does not function but the fuse
corresponding to that system is normal, there
may be a fault in the system elsewhere. We
recommend you to have your vehicle
checked.
CAUTION
 If the newly inserted fuse blows again after a
short time, we recommend you to have the
electrical system checked to find the cause
and rectify it.
 Never use a fuse with a larger capacity than
specified or a substitute (such as a cable or
foil). Doing so could cause the circuit wires
to overheat and create a fire.
Replacement of lamp bulbs
CAUTION
 Do not install commercially available LED-
type bulbs.
Commercially available LED-type bulbs
could adversely affect the operation of the
vehicle, such as by preventing the lamps and
other vehicle equipment from operating
properly.

Bulbs are extremely hot immediately after
being turned off.
When replacing a bulb, wait for it to cool
sufficiently before touching it. You could
otherwise be burnt.
 Handle halogen lamp bulb with care. The gas
inside a halogen lamp bulb is highly pressur-
ized, so dropping, knocking, or scratching a
halogen lamp bulb can cause it to shatter.
 Never hold the halogen lamp bulb with a
bare hand, dirty glove, etc.
The oil from your hand could cause the bulb
to break the next time the headlamps are
operated.
If the glass surface is dirty, it must be
cleaned with alcohol, paint thinner, etc., and
refit it after drying thoroughly.